What is two-zone grilling?
Instead of spreading the coals evenly, you pile them on one half of the grill and leave the other half empty. You now have two cooking areas:
- The direct zone, right above the coals, is very hot. Use it to sear, char and brown.
- The indirect zone, beside the coals, is much cooler. Food there roasts gently in the hot air, especially with the lid closed.
This one change gives you control. If something is browning too fast, move it to the cool side. If a piece needs more colour, move it over the coals. If fat drips and causes a flare-up, you have somewhere safe to move the food.
How to set it up
- Light your charcoal in a chimney starter or with fire starter cubes (see how to light charcoal).
- When the coals are ashed over, pour them onto one side of the charcoal grate. Bank them so they are deeper against the wall.
- Put the cooking grate back, let it heat for 5 minutes, then brush it clean and oil it.
- Start thick foods on the hot side to brown them, then move them across to finish. Thin foods can stay on the hot side the whole time.
For thick steaks, chops and whole chicken legs, many cooks do the opposite: start on the cool side with the lid closed until the meat is nearly at temperature, then finish with a minute or two per side over the coals for a crust. It gives even cooking from edge to centre.
Using the vents
Charcoal burns as hot as the air you feed it. Most kettle grills have a vent underneath and one in the lid.
- Bottom vent: this is the accelerator. Open wide for a hot fire, half-closed for medium, almost shut for low.
- Top vent: this lets hot air and smoke escape, pulling fresh air through from below. Keep it at least partly open, or the fire will choke and food tastes stale and smoky.
- Position the top vent over the food on the indirect side so the hot air and smoke are drawn across it.
Make small changes and wait 10 minutes before changing again. Charcoal reacts slowly, and constant adjusting only confuses things.
Grilling on an open grill or sigri
Many Indian barbecues and street-side grills have no lid at all. Two-zone cooking still works. Bank the coals at one end and use the far end for resting cooked skewers or gently cooking thick pieces. You control the heat by fanning the coals for more heat, and by raising the grate or moving food away for less.
Other useful coal layouts
| Layout | How | Best for |
|---|---|---|
| Full bed | Coals spread evenly across the whole grate | Lots of thin food at once: kebabs, prawns, vegetables for a crowd |
| Two-zone | Coals on one side, empty on the other | Almost everything, especially chicken pieces and thick cuts |
| Three-zone | Deep pile on one side, thin layer in the middle, empty on the other | Parties where you cook several foods at once |
| Ring or split | Coals on both sides, empty in the middle | Whole chicken or a large roast with the lid closed |
| Snake | A line of briquettes two or three wide around the edge, lit at one end | Low and slow cooking for 4 to 6 hours, like ribs |
Frequently asked questions
Do I need a lid for two-zone grilling?
A lid helps a lot for thick foods because it traps hot air around them, turning the cool side into an oven. Without a lid, the cool zone is still useful for resting food and avoiding flare-ups.
How do I lower the heat on a charcoal grill quickly?
Move the food to the side without coals and partly close the bottom vent. Spreading the coals out also lowers the heat. Never pour water on hot coals in the grill: it sends up a cloud of ash and can crack the grill.
Why does my food taste bitter and smoky?
Usually because the top vent was closed, trapping stale smoke, or because cooking started before the charcoal finished smoking. Keep the top vent open and wait until the coals are ashed over.